This week in Mirage #5

Time for the usu­al week­ly devel­op­ment news. This week I worked some more on the water ero­sion mod­i­fi­er.

I start­ed by fix­ing the ran­dom­ness of the rain. Every iter­a­tion 100 drops fall at ran­dom places in the ter­rain. The prob­lem was that I was­n’t keep­ing the seeds for the ran­dom val­ues around so every­time a set­ting changed it would also change the entire ero­sion sim­u­la­tion. That was an easy fix by set­ting the ran­dom seeds to the iter­a­tion num­ber.

Also, rain drops now fall around as a cir­cle with a falloff instead of a square. This has made the effect a bit more real­is­tic (IMHO) but it has a small cost in per­for­mance. However mak­ing bet­ter ter­rains is more impor­tant than absolute speed for now. Specially since there’s so much to opti­mize yet.

The UI is a lot sim­pler now with only four main set­tings.

Springs

Springs are a con­stant source of water, unlike rain which falls ran­dom­ly. They are used to carve canyons or rivers. I’ve added all the func­tion­al­i­ty but I’m still hav­ing some issues with this. I always end up adding too much water in the cen­ter of the spring which cre­ates spikes. It also needs more time than rain to carve the ter­rain.

The springs UI works like the new Terraces mod­i­fi­er, you can add them by increas­ing the springs counter.

Yes, man­u­al­ly writ­ing coor­di­nates sucks I know. But it’s a first step tor­wards an inter­ac­tive mode. Half the work is done to add that in the next ver­sion.

Next week

Next week is the big Blender 2.80 release. I’ll be busy releas­ing the next ver­sion of Mirage (3.3) and the huge Render+ 2.0 update. Hopefully I will still have some time for Rusting. I’m also work­ing on a new Map2D datatype that will make my life so much eas­i­er. It will also improve per­for­mance a lit­tle bit.

Other things left to do:

  • Find a way to pre­vent spikes in springs
  • Make the base ter­rain algo­rithm bet­ter and eas­i­er to use
  • Generate a large heightmap to use as a vec­tor dis­place­ment, then down­scale for the mesh
  • Export 16-bit RAW files for heightmaps
  • Figure out how to make ter­rains seam­less again
  • Probably a ton of oth­er things I broke 🙂

If you want a seat in the first row when the next ver­sion of Mirage comes out you can check it out on the BlenderMarket.

Various(Addon, Blender, BlenderMarket, Development, Mirage, Python)Last updated 20.07.2019
All the posts you can read

No comments yet

Leave a Reply

Your email address will not be published.